This will create miter joints for the boxes to fit together.
Cutting a 45 degree angle with a table saw.
Cut a scrap piece of wood to 45 degrees.
Saw a second piece of scrap wood and then compare how the edges fit together with the first sawed pieces.
Knowing how to cut angles on a table saw will enhance your woodworking projects as will watching any and all of wwgoa s woodworking videos.
Since a table saw s blade can also be set for angles up to 45 degrees the miter gauge allows your saw to make many of the compound cuts that are normally reserved for a compound miter saw or radial arm saw.
If they do not match up well you may need to calibrate your saw again or re square it.
Start by setting the miter gauge to 45 degrees photo 1.
Make sure the saw cuts cleanly through each piece.
The saw blade will try to pull it off line.
Make adjustments as needed.
Mount an extension fence moving it toward the blade far enough to cut the end at a 45 degree angle photo 2.
In this video i am cutting the pieces for my cedar boxes at 45 degrees on my table saw.
If the width of the wood is larger than the height of the saw blade you may want to use a band saw to cut the wood.
The cut quality made using the table saw and taper guide can t be beat.
Depending on your table saw you can adjust the angle of the blade in the range of 45 in either side of the table left or right.
Hold your material very tight.
With a right tilt saw this approach generally dictates working with the rip fence to the left of the blade which can feel a bit awkward at first but you get used to it.
Make the angled cut.
The real problem with beveling on a right tilt saw is that the fence typically only has about 12 of travel to the left of the blade.
First place a piece of scrap wood on the table and saw it at your 45 degree angle.
Set the piece of wood onto the scrap piece and adjust the table for the band saw to the angle measurement minus 45 to make the cut.
Choose a couple of pieces of scrap wood then cut them like you plan on cutting the wood for your project.
If you re cutting a 45 degree angle cut 2 different pieces and try to fit them together.
Then make the fine cuts on your material.
Once the angle has been set you will need to lower the blade down till only about 25 of the blade stays above the level of the table.
