At this step be careful not to slip away the piece.
Cross cutting plywood on a table saw.
Raise the blade to desired depth.
Cutting full sheets of plywood was always a challenge when i didn t have an extra set of hands.
Any board much over 4 ft.
Carefully put a piece of plywood onto the table saw.
Part 5 of 5.
Choose the right blade.
As with the table saw the blade must be appropriate for cutting plywood.
Support one end of long boards on the plywood edge while you crosscut them.
Before you cut your plywood ensure that you have set the blade to the right.
Blades come in various sizes so make sure that you have the right kind for your needs.
At this stage the blade needs to be quite high.
Raising the blades stops the teeth from cutting the underside first and makes for an all round finer cut.
For a cleaner cut raise the blade a couple of inches and this will give a much neater cut.
Clamp a straight length of plywood to the side of a sawhorse level with the saw table.
When you cut plywood with a circular saw then you don t have to worry about the bottom side of the plywood sheet because tear out only happens on the upper side.
However i have noticed many seasoned woodworkers cross cutting against the fence on large plywood pieces that are indeed wider than they are long.
In this video i m cutting a full sheet in half which will be.
When cross cutting plywood with a circular saw flip the good side over so that it s on the bottom.
I understand that cross cutting wide wider than long pieces on the table saw needs to be done with a miter gauge or cross cut sled and not the rip fence due to the lever action created which can pinch the blade and cause dangerous kickback.
Also don t let the blade pull away from this piece from your hand.
Clamp the insert down once the blade goes all the way through.
Use a zero.
Long is tougher to cut accurately because the table on the saw will no longer support it.
Cutting full sheets of plywood mdf osb melamine or particle board can be tricky and even dan.
Top tips for cutting plywood on a table saw if you read your safety manual it is advised to always have the blade on a low setting.
Most tear out will occur on the top of the cut when using a circular saw so whatever tear out you encounter should be on the bad side if you flip it upside down.
How to safely cut full pieces of sheet stock on a table saw.
